A WARNING ABOUT CHARGING BATTERIES
Connecting any rechargeable batteries directly to the output of the unit can crash the DPS device !!!
- In case of polarity reversal – 100% failure of any DPS model.
- When the output voltage of the power supply is turned off, the voltage from the battery will flow back to the power supply. This could damage it. And it 100% burns the DPS5020 / 5015 !!!
- These features are associated with the circuitry of the power supplies and do not depend on the firmware.
- Information about charging in the official manufacturers article is NOT CORRECT!!! https://budgetlightforum.com/node/68429
- To avoid the above charging problems, use an additional diode as shown in the figure below. Consider the amperage and voltage drop across the diode when charging.
- If you find it difficult to understand the above problems, do not charge the batteries using DPS power supplies, use specialized chargers instead.
ПРЕДУПРЕЖДЕНИЕ О ЗАРЯДКЕ АККУМУЛЯТОРОВ
Подключение любых аккумуляторных батарей напрямик к выходу блока, может ВЫВЕСТИ ЕГО ИЗ СТРОЯ !!!!
- При переполюсовке – гарантированный выход из строя любого блока питания
- При отключенном выходном напряжении блока питания, напряжение с батареи будет поступать обратно в блок питания. Это может вывести его из строя. И гарантированно выведет из строя DPS5020/5015 !!!
- Эти особенности связаны со схемотехникой блоков питания и не зависят от прошивки.
- Информация о зарядке в статье официальных производителей НЕТОЧНАЯ!!! https://budgetlightforum.com/node/68429
- Чтобы избежать вышеописанных проблем при зарядке, используйте дополнительный диод, как показано на рисунке ниже. При зарядке учитывайте силу тока и падение напряжения на диоде.
- Если вы затрудняетесь в понимании вышеописанных проблем – не заряжайте аккумуляторы с помощью блоков питания DPS, вместо этого используйте специализированные зарядные устройства.